The PicoCalc manual opens on a disclaimer, and the radio wires are soldered from inside the case
Co-Authored-By: Claude Fable 5.1 <noreply@anthropic.com>
This commit is contained in:
1 parent
4afb70378a
commit
22e3642ca5
1 file changed
+15
-2
+15
-2
@@ -9,6 +9,16 @@ two phases, most of it spent waiting for a toolchain to download; the radio phas
|
||||
soldering iron and can be done later — MeshTerm's `--mock` mode runs perfectly well without
|
||||
a radio in the meantime.
|
||||
|
||||
> ⚠ **Read this first.** This build takes the PicoCalc apart, swaps its core board, and
|
||||
> solders to it. It assumes you can already solder cleanly, use a multimeter, and work with
|
||||
> small electronics without forcing anything. There is a real risk of damaging the
|
||||
> hardware if a step goes wrong — a cracked screen, a snapped shell post, a dead board, or
|
||||
> an overcharged lithium cell — and some of that damage is not repairable. You do this at
|
||||
> your own risk. The author accepts no responsibility for any damage, loss or injury that
|
||||
> results from following this guide, and nothing in it is a warranty that your parts, your
|
||||
> tools or your hands will behave the way the author's did. If you are not comfortable
|
||||
> with any step, stop and get help from someone who is.
|
||||
|
||||
- [Shopping list](#shopping-list)
|
||||
- [Before you start](#before-you-start)
|
||||
- [Three ways to break it](#three-ways-to-break-it)
|
||||
@@ -704,8 +714,11 @@ Four wires, TX and RX crossed:
|
||||
> header. Every signal here is 3.3 V, and there is **no 5 V rail** on this board — power the
|
||||
> XIAO from 3V3 only.
|
||||
|
||||
With the PicoCalc powered off, solder the four wires between the XIAO's pads and the Lyra's
|
||||
header pins as above. Attach the LoRa antenna to the Wio-SX1262's u.FL connector before you
|
||||
With the PicoCalc powered off and the back of the shell removed, solder the four wires
|
||||
between the XIAO's pads and the Lyra's header pins as above. The Lyra can stay seated in
|
||||
its socket: the tops of its header pins are reachable from inside the case, so solder to
|
||||
those. Keep the iron on each pin only as long as it takes, and don't press down on the
|
||||
board. Attach the LoRa antenna to the Wio-SX1262's u.FL connector before you
|
||||
power anything back on — running the radio without an antenna attached can damage it.
|
||||
Wrap the XIAO + Wio-SX1262 stack in Kapton tape so no pad can touch the Lyra, the
|
||||
mainboard or a battery, then tuck it into the shell wherever it fits without straining the
|
||||
|
||||
Reference in new issue
Block a user