diff --git a/docs/picocalc.md b/docs/picocalc.md index beb97c2..9e650e4 100644 --- a/docs/picocalc.md +++ b/docs/picocalc.md @@ -9,6 +9,16 @@ two phases, most of it spent waiting for a toolchain to download; the radio phas soldering iron and can be done later — MeshTerm's `--mock` mode runs perfectly well without a radio in the meantime. +> ⚠ **Read this first.** This build takes the PicoCalc apart, swaps its core board, and +> solders to it. It assumes you can already solder cleanly, use a multimeter, and work with +> small electronics without forcing anything. There is a real risk of damaging the +> hardware if a step goes wrong — a cracked screen, a snapped shell post, a dead board, or +> an overcharged lithium cell — and some of that damage is not repairable. You do this at +> your own risk. The author accepts no responsibility for any damage, loss or injury that +> results from following this guide, and nothing in it is a warranty that your parts, your +> tools or your hands will behave the way the author's did. If you are not comfortable +> with any step, stop and get help from someone who is. + - [Shopping list](#shopping-list) - [Before you start](#before-you-start) - [Three ways to break it](#three-ways-to-break-it) @@ -704,8 +714,11 @@ Four wires, TX and RX crossed: > header. Every signal here is 3.3 V, and there is **no 5 V rail** on this board — power the > XIAO from 3V3 only. -With the PicoCalc powered off, solder the four wires between the XIAO's pads and the Lyra's -header pins as above. Attach the LoRa antenna to the Wio-SX1262's u.FL connector before you +With the PicoCalc powered off and the back of the shell removed, solder the four wires +between the XIAO's pads and the Lyra's header pins as above. The Lyra can stay seated in +its socket: the tops of its header pins are reachable from inside the case, so solder to +those. Keep the iron on each pin only as long as it takes, and don't press down on the +board. Attach the LoRa antenna to the Wio-SX1262's u.FL connector before you power anything back on — running the radio without an antenna attached can damage it. Wrap the XIAO + Wio-SX1262 stack in Kapton tape so no pad can touch the Lyra, the mainboard or a battery, then tuck it into the shell wherever it fits without straining the