The seam blurs under 0.10 again: the tighter 0.035 left wedges a reader had to hunt for
Set by eye on the same ladder: at 0.10 the solid point is found at one cell without looking for it, and the safe side of the line is the blur, since a wrong blur still draws a legible seam and a wrong interlock draws none. The shade stays at 0.10. Co-Authored-By: Claude Fable 5.1 <noreply@anthropic.com>
This commit is contained in:
1 parent
2b0f42d1cc
commit
3aa2916846
1 file changed
+8
-6
@@ -272,12 +272,14 @@ def _style_hex(style: str) -> str | None:
|
||||
#: blurred too little there and too much here, and an sRGB distance would only have
|
||||
#: restated the hue gap (a fixed byte step is a near-constant ``55``–``60`` of 8-bit RGB
|
||||
#: all the way round). The value was then set by eye on a ladder of the spectrum's own
|
||||
#: pairs drawn both ways (JP, 2026-09-16): the solid point stays findable at one cell
|
||||
#: down to a little under two noticeable differences, and below that the wedge is gone.
|
||||
#: So the interlock is the ordinary seam and the thin chevron is for fills that are the
|
||||
#: same or as good as — a mirrored leg, a keyless run, the greens' nearest neighbours
|
||||
#: (``0x10`` of green is ``0.026`` and blurs; ``0x10`` of red is ``0.124`` and doesn't).
|
||||
SEAM_BLUR = 0.035
|
||||
#: pairs drawn both ways (JP, 2026-09-16), and it sits where the solid point is not just
|
||||
#: detectable at one cell but *found* without looking for it: ``0.10``, five noticeable
|
||||
#: differences, the typical ``0x10`` pair with a little to spare. Tighter (``0.035`` was
|
||||
#: tried) left wedges a reader had to hunt for; the safe side is this one, since a wrong
|
||||
#: blur still draws a legible seam and a wrong interlock draws none. ``0x10`` of green is
|
||||
#: ``0.026`` and blurs; ``0x10`` of red is ``0.124`` and doesn't; the two greys, ``0.18``
|
||||
#: apart, keep their interlock on the metric alone.
|
||||
SEAM_BLUR = 0.10
|
||||
|
||||
#: How far the thin chevron's colour steps from the fill it is drawn in, in OKLab ``L``
|
||||
#: — a lightness shift alone, so it reads as *that chip's colour, shaded* rather than as
|
||||
|
||||
Reference in new issue
Block a user