Expose the Full Companion terminal over TCP and add an authenticated, replay-resistant host command service with documented CPU temperature, reboot, and allowlisted program examples.\n\nImprove LoRa OTA diagnostics and persistent CLI handling, reduce clock correction drift to ten minutes, and make mOTA stream flush behavior an explicit transport policy with regression coverage.
MAX_CLIENTS is defined in both src/helpers/ClientACL.h and examples/simple_repeater/MyMesh.h. Appears it was centralised in the former header file some time ago. Both are included in some places and, depending on which order they're in, either value can win.
This change drops the duplicate entry from the repeater firmware and bumps the central limit up to 32 (per the original repeater firmware value).
Changes:
- Remove MAX_CLIENTS from repeater MyMesh.h
- Increase MAX_CLIENTS limit in ClientACL.h to 32
Boards without a charge-complete signal only infer "full" from voltage, and
a real pack rarely reads the full BATT_MAX_MILLIVOLTS (4.2V), so the plug icon
was effectively never shown. Treat "full" as a high band (>= 95%) so the plug
appears when the battery is charged rather than requiring an exact 100%.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Show a small lightning-bolt icon to the left of the battery indicator on
the ui-new home screen while the device is externally powered, and a plug
icon once the battery reads full. The bolt/plug sits beside the battery so
the fill bar stays clean and uninterrupted. When a buzzer is present, the
mute icon shifts one slot further left so the two never overlap.
Charging state is derived from board.isExternalPowered(), so this works on
any board that reports external power (e.g. the nRF52 VBUS-detect path).
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
thinknode_m8: initial support
adds some functionalities to ui_task and epddisplay:
epd display,
- supports screen off, and clear screen
- supports forcing full refresh every N partial refreshes (off by default, configured to 60 for M8)
ui_task
- UI_SHOW_CLOCK flag to display clock on first screen
- rotary button can act like joystick (with regards to Enter key), defaults to old config for existing nodes
- screen off on long press when using rotary button (very handy for the watch)
mikecarper
Scott Powell
liamcottle
Florent
Kevin Le
entr0p1
agessaman
hansimgamrandClaude Opus 4.8
Huw Duddy
Rastislav Vysoky