Add selectable shared ESP-NOW channels, raw/wrapped bridge compatibility, and bounded fragmentation for maximum-size packets.\n\nGive ESP32 Full profiles WiFi coexistence, stabilize WebConfig and USB terminal lifecycles, and keep disabled bridges stopped during observer updates.\n\nUpdate generated UI, firmware selection, documentation, and regression coverage.
Adapt the validated fan thermostat, battery ADC calibration, GPS baud, SX1262 register patch, and 1700us PA ramp behavior from mintylinux/Meshcore-T-beam-1W-Firmware to the current board architecture. Also make Arduino 3 full-build dependency switching reliable after standard ESP32 builds and guard the release hardware contract with regression coverage.
Add the framed BLE mOTA transport and companion control path, complete the full-profile build and runtime fixes, and document and test the OTA workflow.
Expose the Full Companion terminal over TCP and add an authenticated, replay-resistant host command service with documented CPU temperature, reboot, and allowlisted program examples.\n\nImprove LoRa OTA diagnostics and persistent CLI handling, reduce clock correction drift to ten minutes, and make mOTA stream flush behavior an explicit transport policy with regression coverage.
The contact sync streams up to MAX_CONTACTS frames back to back, but
ArduinoSerialInterface never checked whether the stream could take
them: isWriteBusy() returned false unconditionally, so MyMesh's pacing
gate had no effect, and writeFrame() called write() without looking at
availableForWrite(). On ESP32 (HWCDC, 256 byte TX ring) a host that
stalls for a moment makes the driver drop queued bytes silently, which
tears a frame in half - and since the framing is length prefixed with
no checksum and no resync marker, the client stays desynchronised for
the rest of the session. Reported as 'the app disconnects while
syncing contacts' on devices with a large contact list.
Add opt-in flow control: report busy until a whole frame fits, and
drop frames as a unit instead of tearing them. Enable it for the
companion USB interface and give HWCDC a bigger TX buffer with a short
write timeout, mirroring what kiss_modem already does.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
ArduinoSerialInterface::isConnected() always returned true, so any
companion build with a USB interface believes a client is attached from
boot onwards. Two user visible effects:
- new message notifications never fire, because MyMesh only notifies
the UI (display, buzzer) while no client is connected
- on builds that also expose BLE the home screen shows '< Connected >'
instead of the BLE pairing PIN, so a freshly flashed device cannot be
paired at all
Add an optional connection check callback and wire it up per platform:
native USB-CDC (TinyUSB on nRF52/RP2040/ESP32 with USB_MODE=0) exposes
real DTR through (bool)Serial. The ESP32 USB-Serial-JTAG peripheral has
no DTR concept - it reports 'connected' as soon as the host enumerated
the device - so fall back to frame activity there. Plain UARTs keep the
previous assume-connected behaviour.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
mikecarper
Kevin Le
rootandClaude Fable 5
liamcottle