Organize the planning-session outputs into hardware/, firmware/, palm-client/ and docs/, with design notes and a progress tracker.
1.5 KiB
1.5 KiB
Progress
Milestones
Hardware: SB-LoRa v0.1
- Board designed, DRC clean, fab package generated
- Check part rotations in JLC preview (U1–U7, Y1, D1)
- Order PCBs + assembly (2-layer, 1.6 mm, ENIG)
- Order J1 (Hirose IC1HA-68RD-1.27SH(51), DigiKey HR1187-ND) and 2x 1x7 female headers
- Bare board: continuity check, dry-fit in Visor slot
- Fit J1, bench-power VSB at 3.3 V, check current and 14.7456 MHz on Y1
- In Visor: read/write SC16IS740 scratch register (SPR, 0x07) from Palm side
Firmware
- Apply
firmware/meshcore-xiao-nrf52-uart-companion.patchto MeshCore, buildXiao_nrf52_companion_radio_uart - Bench-test over 3.3 V USB-TTL on D6/D7 with meshcore-cli
- Plug stack into carrier;
CMD_DEVICE_QUERYgets a DEVICE_INFO reply
Palm client
- Toolchain set up (prc-tools or CodeWarrior, Palm OS 3.5 SDK, HsExt headers)
- POSE running a 3.5.2H3 Visor ROM
- Port springSD bus routines; SC16IS740 driver
- Companion protocol framing + minimal command set
- UI: contacts, DMs, channels
- Install method confirmed (HotSync or CF adapter)
Open questions
- Which CF adapter is it, and does its ROM include an app installer?
- Is the J1 footprint correct against the Hirose drawing? (Only checked against springSD.)
- Does the extension clear the Visor body? Is the slot-opening alignment right?
Log
2026-10-30
- Planning done in claude.ai. Chose a custom Springboard module (SB-LoRa) over cradle serial/IR.
- SB-LoRa v0.1 fab package generated. Repo set up and files organized.