MeshCore has carried companion-over-hardware-UART for a long time — the defines
SERIAL_RX/SERIAL_TX, packaged per board as a *_companion_radio_serial env, and the
ESP32-S3 twin of this very board already uses the same D6/D7 pads. Our patch was
reimplementing it for the one platform it had never been wired into: at our old pin the
SERIAL_RX branches lived inside the ESP32 and RP2040 blocks and nRF52 fell through to
Serial. So the patch is now the two things actually missing, both upstream-shaped and
submitted: a Serial1 reference so the shared block compiles on nRF52, and the
Xiao_nrf52_companion_radio_serial env carrying the I2C escape in build_unflags rather
than editing the flags every XIAO env inherits.
Pin moves to a dev commit, since dev is the branch MeshCore takes work on.
flash.py grew the check that was missing when it mattered: a drive letter is not an
identity — when one board leaves the USB bus another inherits its letter — so it now
reads INFO_UF2.TXT and refuses a bootloader that isn't a XIAO, or that carries S140
6.1.1 and would take this S140-v7 image at the wrong address and never boot. It also
stops pretending copy-to-drive is the only route: our bootloader exposes a serial port
and no mass storage at all, so it prints the serial-DFU command instead of a dead end.
Verified from a clean clone at the new pin: env builds, uf2 converts to the same 811008
bytes at 0x27000 that is now running on the radio, and both Xiao_nrf52_companion_radio_usb
and Xiao_S3_WIO_companion_radio_serial still build, so neither side of the new #if moved.
Complete, reproducible bring-up for giving a PicoCalc (Luckfox Lyra, Calculinux) a
MeshCore radio via a Seeed XIAO nRF52840 + Wio-SX1262 on the Lyra's hardware UART1:
- README.md -- parts, wiring, build -> flash -> setup, the why, troubleshooting
- build-firmware.sh -- clone + patch MeshCore, build the _usb env, emit the .uf2
- flash.py -- flash the .uf2 via the XIAO UF2 bootloader (Win/Linux/Mac)
- lyra-setup.sh -- boot-persistent UART1->GP4/GP5 mux service, dialout, profile
- uart1-mux.py -- the RK3506 matrix-IO register poke that routes UART1
- meshcore-uart1.patch -- the two firmware edits (Serial1 bind; I2C off D6/D7)
The two firmware edits are both required: bind the companion to hardware UART1
(Serial1 = D6/D7) instead of USB, and move I2C off D6/D7 (MeshCore maps it there and
sensors.begin() would otherwise seize the UART pins). Also documented in the top-level
scripts/README.md alongside the Calculinux and uConsole-SPI targets.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>