From 18517f88dbaa844dc5715b3d476d6adb22157cea Mon Sep 17 00:00:00 2001 From: Jean-Pierre Martineau Date: Tue, 15 Sep 2026 01:31:36 -0400 Subject: [PATCH] The back panel may need a filed cutout and a snipped grille to close over the Lyra and its Wi-Fi lead Co-Authored-By: Claude Fable 5.1 --- docs/picocalc.md | 14 +++++++++++++- 1 file changed, 13 insertions(+), 1 deletion(-) diff --git a/docs/picocalc.md b/docs/picocalc.md index 9bdddf7..8408c52 100644 --- a/docs/picocalc.md +++ b/docs/picocalc.md @@ -82,7 +82,8 @@ a radio in the meantime. | 2.5 mm hex key | Comes with the PicoCalc kit. | | USB-C data cable | For the serial console, and later for flashing the XIAO. A charge-only cable won't do; it has to carry data. | | microSD card reader | For writing the Calculinux image from your PC. | -| Small side cutters | For trimming wire ends. | +| Small side cutters | For trimming wire ends, and a section of the case grille if the Wi-Fi lead needs the room. | +| Small needle file | To open the back panel's USB-C cutout a little if the Lyra's connector doesn't clear it. | | Kapton (polyimide) tape | Wraps the XIAO stack and the DIY USB lead so nothing bare touches the board or the shell. Heat-proof, thin, and it peels off cleanly. | | A PC (Windows/macOS/Linux) with Python 3 and git | Runs the image-writing, firmware-build and flashing steps. | @@ -246,6 +247,11 @@ screwed down. You should see the Lyra sitting flat on the socket with no gap at either end, and, once the mainboard is back in, its USB-C port centred in the back-panel cutout. +The cutout was made for the Pico's micro-USB, and the Lyra's USB-C connector is a +different shape. Depending on the connector Luckfox fitted to your board, the back panel +may not close over it. If it catches, open the hole a little with a small needle file, +testing the fit as you go, until the panel sits down without pressing on the board. + Leave the back off for now. The microSD card goes into the **Lyra's own slot** in [Step 4](#step-4--write-the-image-to-the-microsd), and that slot is easier to reach with the board exposed. @@ -281,6 +287,12 @@ MX1.25 end into the socket on the Lyra — it is keyed and only goes in one way Wi-Fi dongle into the USB-A end. Lead and dongle stay inside the shell; tuck them where they don't press on the board. +The MX1.25 socket sits on top of the Lyra, and the lead leaves it upward, which is where +the back panel's grille is. The wire may interfere with the grille when the back goes on. +If it does, snip a small section out of the grille with the side cutters where the wire +passes and shape the edge until nothing presses on the plug or the wire. Better to remove a +sliver of plastic than to close the case against a connector. + > **The Lyra's USB port is 3.3 V, not 5 V.** A standard 5 V USB Wi-Fi dongle will not work > and may damage the board. Stick to the tested chipsets — RTL8192CU, R8712U, or RTL8188EU > — which is why the shopping list names a known dongle (the TP-Link TL-WN725N) and