Five "Default:" values in cli_commands.md no longer matched the firmware:
- radio / freq: the default preset moved to EU/UK (Narrow) in b777a7c6,
changing LORA_FREQ/BW/SF from 869.525/250/11 to 869.618/62.5/8
(platformio.ini:29-31). No variant overrides these, and LORA_CR is 5
on every path, so the full preset is 869.618,62.5,8,5.
- flood.advert.interval: raised to 47 hours in 40180b8f for both repeater
and room server; sensor leaves it disabled.
- advert.interval: prefs store minutes/2 and the getter doubles on read, so a
factory-fresh node reports 2, not 0. But savePrefs() zeroes any interval
below the 60 minute minimum (CommonCLI.cpp:162-165), and it is called from
every `set` handler -- so the value becomes 0 as soon as the node is
configured. Documented both states, since neither alone is the whole story.
- direct.txdelay: repeater defaults to 0.3, room server and sensor to 0.2.
Sources: platformio.ini:29-31, simple_repeater/MyMesh.cpp:893,903-904,
simple_room_server/MyMesh.cpp:650,661-662, simple_sensor/SensorMesh.cpp:716,
726-727, CommonCLI.cpp:162-165,680-681.
Reserve board-specific GPIOs, make ESP-NOW channel/format handling configurable, and coordinate WiFi, BLE, NTP, MQTT, and host actions safely.
Add the Indicator message page, exclusive transport selector, dynamic 480/320 rendering, larger transport typography, pairing cleanup, and corresponding tests and documentation.
Add durable TempRadio, ACL, clock, bridge, GPS/I2C, USB logging, and Indicator recovery safeguards together with expanded automation, build/profile contracts, release metadata, and the hardware validation ledger.
Add selectable shared ESP-NOW channels, raw/wrapped bridge compatibility, and bounded fragmentation for maximum-size packets.\n\nGive ESP32 Full profiles WiFi coexistence, stabilize WebConfig and USB terminal lifecycles, and keep disabled bridges stopped during observer updates.\n\nUpdate generated UI, firmware selection, documentation, and regression coverage.
Add the framed BLE mOTA transport and companion control path, complete the full-profile build and runtime fixes, and document and test the OTA workflow.
Expose the Full Companion terminal over TCP and add an authenticated, replay-resistant host command service with documented CPU temperature, reboot, and allowlisted program examples.\n\nImprove LoRa OTA diagnostics and persistent CLI handling, reduce clock correction drift to ten minutes, and make mOTA stream flush behavior an explicit transport policy with regression coverage.
PA PL1 re-targets the PA's DC-DC supply rail rather than selecting a
logic-level gain, and the serial CLI is serviced on every main-loop pass
regardless of whether a transmit is in flight. A `set radio.fem.txgain`
write could therefore move the rail mid-transmit, while the SX1262 was
still driving the PA at full input power.
Record the requested level in setPAGainEnable() and drive the pin from
setTxModeEnable(), which runs from onBeforeTransmit() ahead of
startTransmit(). The level only matters while transmitting, so deferring
costs nothing.
Document that the pref is saved immediately but applied at the next
transmit, so `get radio.fem.txgain` can lead the hardware until then.
mikecarper
Jarosław Domański
Robert Ekl
IoTThinks
Kevin Le
Adam Gessaman