Add meter-reference calibration with saved ADC corrections, checked persistence and rollback. Preserve existing board coefficients and nRF52 voltage policy, and merge the Mini Repeater feature gates.
Validation: 69 focused tests, hosted documentation checks, and four firmware builds passed. Mini Repeater retains calibration and its existing filesystem with 376 flash bytes free; earlier Mini Sensor size failures remain documented.
Add get leds and set leds on|off for Companion, repeater, room server and
sensor builds. Preserve the setting across reboots and cover GPIO, RGB,
Bluetooth, notification and expander indicators without changing radio
amplifier controls or screen backlights.
RAK Companions blink while advertising and keep the Bluetooth LED off once
connected, including late timer callbacks.
Adapted from meshcore-dev/MeshCore#3605 and #2694.
Validated with host regressions and firmware builds for SenseCAP Solar,
RAK4631, T096, Heltec V4, T-Beam, Xiao S3, Pico W and Wio E5 Mini.
Co-authored-by: R0ck <develop@hectospark.co.uk>
Co-authored-by: Nick Dunklee <nick@dunklee.org>
Integrate upstream 1.18.0, delayed direct ACK forwarding, zero-scope routing, Waveshare LR1121 and dynamic WiFi variants. Preserve fork chemistry-aware power management and bounded multi-interface UI; retain retry/dedup safety while adding upstream ACK delay. Qualify LR1121 band power and HP-only Morse handling with native regressions.
Switch these existing variants from `nrf52_base` to `rak4631_hw` (which adds
ENABLE_OTA + the in-place flash store + the EndF post-build hook), so they get
OTA-over-LoRa. Scope is limited to variants already covered by the
Adafruit_nRF52_Bootloader_OTAFIX in-place apply — no new variants are added.
OtaTargets.h is regenerated to include their target ids.
Sensors connected via the Grove I2C connector (D18/D17) were not detected
because the firmware scanned the OLED I2C bus (Wire, D14/D15) by default.
Adding ENV_PIN_SDA/SCL flags directs EnvironmentSensorManager to use Wire1,
matching the physical Grove connector pinout.
Co-Authored-By: Claude Opus 4.6 <noreply@anthropic.com>
As all NRF52 boards now have OTA support, let's remove the subclass
and integrate it into the base class.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
The startOTAUpdate() is the same for all NRF52 boards. Use a common
implementation for all boards that currently have a specific
implementation.
The following boards currently have an empty startOTAUpdate() for
whatever reasons and therefore are not inheriting NRF52BoardOTA to
keep the same state: Nano G2 Ultra, Seeed SenseCAP T1000-E,
Wio WM1110.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
Some NRF52 boards are able to use the internal power-efficient DC/DC
regulator. Add a new class that can be inherited by board classes to
enable this feature and reduce the power consumption.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
Use a common begin() method that can be called from derived classes
to contain the shared initialization code.
Signed-off-by: Frieder Schrempf <frieder@fris.de>
* MomentaryButton: new constructor 'multiclick' param
* WIoTrackerL1: now just use joystick, joystick press for KEY_ENTER, no multi-click for snappier UI