Switch eight S3 board defaults and 78 remaining TinyUSB recipes to hardware Serial/JTAG while preserving UART and other platforms. Restore retained S3 PHY ownership after a TinyUSB OTA restart and prepare KISS queues before enabling the driver.
Add real recipe resolution, Companion/KISS transport sanitizer coverage, and RF lifecycle reset regressions to CI. Native tests pass 1765/1765; SDK, transport, recipe and USB watchdog checks pass. Board and role cross-compilation and physical OTA qualification continue.
Read identities up to three times before allowing replacement, publish only complete reads, and require new startup keys to be saved with bounded retries.
Use authoritative replay-file metadata throughout persistence and clock recovery. Validate setperm input before narrowing or mutating roles, and add production-path regression coverage.
Adapt the validated fan thermostat, battery ADC calibration, GPS baud, SX1262 register patch, and 1700us PA ramp behavior from mintylinux/Meshcore-T-beam-1W-Firmware to the current board architecture. Also make Arduino 3 full-build dependency switching reliable after standard ESP32 builds and guard the release hardware contract with regression coverage.
setTxTimeoutMs() and setTxBufferSize() are HWCDC-only APIs; calling
them on HardwareSerial (UART-bridge boards like T-Beam) fails to compile.
Co-Authored-By: Adam Gessaman <adam@gessaman.com>
Switch ESP32-S3 KISS modem environments to HWCDC and move outbound KISS writes to a non-blocking queued frame path so loop() and TX completion keep progressing when the host reads slowly. Add native backpressure regression tests and correct the native_kiss_modem test filter so this suite runs directly with pio test.
Framework for upcoming variant-specific PRs that add LED feedback during boot. The hook gives users visual cues that the device is busy and
shouldn't be interacted with until startup completes.
- Trigger noise floor calibration every 2s and AGC reset every 30s in main loop.
- Reorder loop to match Dispatcher: calibrate + radio.loop() before AGC reset
and recvRaw() so RSSI is never sampled right after startReceive().
- Update protocol doc with calibration intervals and typical noise floor range.
- Variant platformio.ini updates (heltec_v3, rak4631).
mikecarper
Scott Powell
ViezeVingertjesandAdam Gessaman
AtlavoxDev
Rastislav Vysoky