Default Cascade profiles to CAD off
This commit is contained in:
1 parent
3291b9311f
commit
dfd102c96a
6 files changed
+11
-8
No files matched your search
@@ -2051,7 +2051,9 @@ The pin number is the Arduino pin number used by that target (the normal GPIO nu
|
||||
|
||||
**Description:** When enabled, the radio performs a hardware Channel Activity Detection scan before transmitting and defers if the channel is busy. Runs independently of `int.thresh` - either, both, or none may be active.
|
||||
|
||||
The Cascade firmware profile defaults CAD to `on`; target-default builds continue to default it to `off`.
|
||||
Fresh Cascade-profile builds default CAD to `off` across all roles, including
|
||||
Companion. Saved CAD settings take precedence after an upgrade. Use `set cad off`
|
||||
to disable it on an existing node or `set cad on` to enable it explicitly.
|
||||
The repeater applies the saved toggle to the radio during its periodic
|
||||
noise-floor service. With one runnable packet, a busy result uses the normal
|
||||
CAD retry delay and allows roughly four seconds of continuous busy results.
|
||||
|
||||
Reference in new issue
Block a user