Add runtime FEM control and fix full Companion boot

This commit is contained in:
mikecarper committed 2026-08-10 17:10:18 -07:00
1 parent f40615ab56
commit 968ca3363b
10 files changed
+162 -28

No files matched your search

+15 -1
View File
@@ -39,7 +39,7 @@ bash build.sh build-firmware RAK_4631_companion_radio_full \
--firmware-version v1.17.0
```
To build every available full Companion target, select the corresponding
To build every canonical full Companion target, select the corresponding
interactive menu item or run:
```bash
@@ -47,6 +47,20 @@ bash build.sh build-full-companion-firmwares \
--firmware-version v1.17.0
```
Heltec `_femon` Companion firmware can switch the external FEM receive gain at
runtime, so the Companion bulk-build commands omit the redundant legacy
`_femoff` targets. Those targets remain available through an explicit
`build-firmware` command for compatibility. In WebConfig, use the **FEM RX
boost** switch. From the USB terminal, use:
```text
get radio.fem.rxgain
set radio.fem.rxgain off
set radio.fem.rxgain on
```
The selected state is applied immediately and retained after reboot.
Artifacts are written to `out/` by default.
On 4 MB ESP32 boards, the full target uses a single 3 MB application
+10
View File
@@ -84,6 +84,16 @@ set af {air-time-factor}
```
Sets the transmit air-time-factor. Deprecated - use `set dutycycle` instead.
```
get radio.fem.rxgain
set radio.fem.rxgain {on|off}
```
Shows or changes the external FEM receive-path LNA on supported Heltec boards.
The change is applied immediately, saved across reboots, and recalibrates the
radio noise floor. This is separate from the SX126x `radio.rxgain` setting.
Boards whose FEM receive path cannot be controlled report the setting as
unsupported.
```
time {epoch-secs}