merge: upstream/dev into observer-firmware-dev
Brings in the external FEM gain preferences (fem_txgain, PR #3137 plus the companion-side port), the AGC reset rxgain fix, the LR2021 preamble/IRQ timeout logic, and assorted variant fixes (T096, T-Echo Card TCXO, promicro pinmap, minewsemi, R1 Neo). Conflict resolutions: - SH1106Display: both sides fixed T-Beam Supreme startup independently. Kept our _initialized guard and DISPLAY_ADDRESS_ALT override, took upstream's SA0-pair fallback and its unconditional display.begin() so the frame buffer is allocated even when no panel answers. - MyMesh/SensorMesh/CommonCLI: took upstream's fem_txgain default and wiring, kept our comments and the observer-side prefs layout. Also fixes CustomLLCC68Wrapper, which upstream missed when sx126xResetAGC gained its rx_boost_gain parameter. No variant builds that wrapper today, so neither tree failed to compile.
This commit is contained in:
commit
7e1a94358b
41 files changed
+521
-153
No files matched your search
@@ -305,6 +305,22 @@ Elsewhere it replies `Err - neighbors not enabled in this build`. If a
|
||||
|
||||
---
|
||||
|
||||
#### View or change the LoRa FEM transmit-path gain state on supported boards
|
||||
**Usage:**
|
||||
- `get radio.fem.txgain`
|
||||
- `set radio.fem.txgain <state>`
|
||||
|
||||
**Parameters:**
|
||||
- `state`: `on`|`off`
|
||||
|
||||
**Notes:**
|
||||
- This controls a software-selectable external LoRa FEM transmit gain where the board supports it.
|
||||
- On Station G3, remove the PA PL1 jumper to allow software control. `on` selects PA PL1 high/short and `off` selects PA PL1 low/open. The PA PL2 hardware jumper determines whether this switches between power levels 1/3 or 2/4.
|
||||
- Select an operating level and SX1262 transmit power that comply with local RF limits and the Station G3 power-supply requirements.
|
||||
- The setting is saved immediately, but on Station G3 the level is applied to the hardware at the start of the next transmit, so that the PA supply rail is never re-targeted while the PA is being driven. `get` reports the configured state, which may lead the hardware until the node next transmits.
|
||||
|
||||
---
|
||||
|
||||
### System
|
||||
|
||||
#### View or change this node's name
|
||||
|
||||
Reference in new issue
Block a user