Include runtime ESP-NOW in Full ESP32 repeaters

This commit is contained in:
mikecarper committed 2026-10-05 17:33:02 -07:00
1 parent 6cd1289c8b
commit 69d9ac84bc
21 files changed
+1098 -104

No files matched your search

+12 -8
View File
@@ -193,17 +193,21 @@ Normal repeater firmware includes runtime-controlled RS-232 support where the
board has room; use `set bridge.enabled on` after configuring `bridge.uart` and
`bridge.baud`. The Wio-E5 remains the capacity exception and offers a separate
RS-232 image. Choose Wi-Fi MQTT under **Logging / MQTT**; it is an output mode,
not a second connection choice. Repeaters may still offer separate ESP-NOW or
Ethernet bridge firmware because those paths use different compiled drivers.
not a second connection choice. Full ESP32 LoRa repeaters include runtime
ESP-NOW when capacity permits; dedicated ESP-NOW images remain for measured
capacity exceptions. Ethernet still needs its exact hardware recipe.
For commands and option explanations, follow the
[ESP-NOW bridge setup guide](espnow_bridge_setup.md).
An ESP-NOW bridge target keeps LoRa as its primary mesh radio. Expanded ESP32
Full repeater and room-server images combine ESP-NOW with WiFi MQTT in the
same firmware. MQTT and ESP-NOW are independent runtime transports: use
`set mqtt.enabled on|off` for MQTT and `set bridge.enabled on|off` (or
`set espnow.enabled on|off`) for ESP-NOW, so either or both can run. Both use
Full LoRa repeaters include ESP-NOW, including boards without an MQTT
recipe. Existing MQTT-backed Full repeater and room-server images combine
both transports. Use `set espnow.enabled on|off` for ESP-NOW and, where
supported, `set mqtt.enabled on|off` for MQTT. Newly combined ordinary
repeaters start with ESP-NOW off until explicitly enabled, including the first
upgrade from unmarked legacy preferences. Later reboots preserve that setting.
On combined RS-232 boards `bridge.enabled` controls the UART independently. Both use
one 2.4 GHz radio, so when both are enabled the ESP-NOW bridge channel must
match the connected WiFi access point's fixed channel. ESP-NOW-only mode does
not require WiFi credentials. Its runtime
@@ -214,8 +218,8 @@ backward-compatible bridge-to-bridge default using `bridge.secret`) or `raw`
firmware choice, not two board images. Match `bridge.channel` to the primary
nodes' `espnow.channel` before selecting `set bridge.format raw`.
For Heltec V4 specifically, `companion_radio_full` is still a LoRa-primary
Companion; choose the existing `heltec_v4_repeater_bridge_espnow` firmware to
make that board the LoRa/ESP-NOW gateway. Use its exact merged artifact when
Companion; choose the combined `heltec_v4_repeater` Full firmware and enable
ESP-NOW to make that board the LoRa/ESP-NOW gateway. Use its exact merged artifact when
changing roles or partition layouts.
## Share a selection